Switch to full style
Post a reply

Re: "wavy" blade.

Tue Feb 05, 2013 9:38 am

Ah, ok. It may have warped during the quench of the heat treating. If the whole blade is wavy, it's not the grind.

Re: "wavy" blade.

Tue Feb 05, 2013 1:13 pm

The blade faces on these ITKs are super wavy. They usually flatten out within a half inch of the edge, though. Overgrinds, usually at the heel, are not uncommon. An overgrind anywhere else down the blade can lead to problems.

Not sure if I'm clear...are these waves at the edge or within a half inch of the edge? Or are they higher? It would take a whole lot of sharpening and thinning to expose a hole that high up...

Re: "wavy" blade.

Tue Feb 05, 2013 1:17 pm

Sorry Jared,

It sounds like you might have a lemon. Send it back so I can take a look at it. Most likely I'll just give you a refund and you can try something else.

Re: "wavy" blade.

Tue Feb 05, 2013 1:50 pm

Thanks a lot Mark. Loyal customer through your site for reasons like this. Ive read you always take care of a problem promptly, now I see it holds true.

Re: "wavy" blade.

Fri Feb 08, 2013 8:17 pm

Hi Jared,

I got the knife back and the grind looks fine to me but I'm not sure yet until I take it to the stones.

I'll sharpen it this weekend and let you know the result.

Re: "wavy" blade.

Sat Feb 09, 2013 6:32 am

Jared08 wrote:Looking down the blade there are slight imperfections visible, also looking down the spine it is noticeable. The wave can be felt by pinching the blade by the handle and sliding towards the tip.


yeahhh i agree with you.. its true ^_^
__________________________________
"I love Rambo movies that's why I have a collection of yellowhorse knives
rAmb0 fAnAt1c"

Re: "wavy" blade. no more....

Fri Feb 22, 2013 9:16 am

This knife was a pretty easy fix. We resharpened it and sent it back to Jared. The edge came out nice.
Post a reply