It is currently Tue Dec 23, 2014 3:08 am



Welcome
Welcome to chefknivestogo

You are currently viewing our boards as a guest, which gives you limited access to view most discussions and access our other features. By joining our free community, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content, and access many other special features. In addition, registered members also see less advertisements. Registration is fast, simple, and absolutely free, so please, join our community today!





 Page 1 of 1 [ 3 posts ] 
Author Message
 Post subject: Stropping question
PostPosted: Sat Aug 18, 2012 2:04 am 

Joined: Sat Aug 18, 2012 1:56 am
Posts: 10
Hey guys im new to the forum and was hoping some people might have some advice. I purchased Borone carbide 1mic to put on balsa. I also purchased a 16k stone reading a review from the past saying how well they liked the combo of a 16k stone and boron strop even though they were the same grit. After purchasing I noticed that the shapton glass 16k is acctulay .92 micron, my question is because the stone is acctualy slightly more fine then the strop compound is this still effective? and also do people progressive through strops in the sense of grit, after finishing with stones does it make sense to go through compounds from 1 mic to .125mic or just choose one that i like to finish the knife with. Thanks for any help!


Offline
 Profile  
 
 Post subject: Re: Stropping question
PostPosted: Sat Aug 18, 2012 11:14 pm 
Site Admin
User avatar

Joined: Thu Apr 19, 2012 7:18 pm
Posts: 7897
Location: Madison Wisconsin
This is a good question for a microscope to answer. I always feel like my edge improves after I strop with compound on either balsa or leather so my guess is it will improve the edge for you too. One reason is stropping for me is a different motion and I use only edge trailing strokes in a sweeping motion so I use this as a way to even out any minor edge imperfections that my sharpening job left from the stones. It can't hurt...



_________________
Mark Richmond
Chefknivestogo

Chefknivestogo New Arrivals
Offline
 Profile  
 
 Post subject: Re: Stropping question
PostPosted: Sun Aug 19, 2012 8:16 pm 
Forum Moderator
User avatar

Joined: Mon Apr 23, 2012 4:45 am
Posts: 1498
It is a good question. The difference in grit size .92 microns vs 1 micron is of no importance. The variance in particle size will actually overlap. What
IS important is the type of compound. So the stone is Aluminum oxide based and compounds in this size are typically poly and mono diamond, Cubic Boron Nitride, Boron Carbide and Silicon Carbide, listed roughly in order of hardness.

I have observed improved edge performance following a 16k GlassStone with 1 micron CBN. So even though they are of the same grit, the edges produced are different. I have not done this for all types of steels, so results here may vary, but this is pretty consistent for the ones I've tried. Grit size is just one variable.

---
Ken



_________________
My Facebook Page
Ken'sCorner
Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 3 posts ] 


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


suspicion-preferred