We have a massive amount of Edge Pro products so we figured it would be good to have a whole section on how to use the machine and what to use on it.
Tue Jun 18, 2013 2:39 am
Curious to know if anyone has had this problem and if you have any suggestions. I'm pretty good with the EP and after going 220, 330, 600, and then a loaded strop, I can get the back 2/3 of the blade very sharp. But despite being very conscientious about making sure that all blade sections i sharpen are parallel to the edge of the machine, I can never get the front third (near the tip) to shave hair. Anyone had a similar experience? Any tips?
Tue Jun 18, 2013 4:04 am
Did you raise a burr in that section?
Tue Jun 18, 2013 7:09 am
The tip being thinner & narrower tends to flex and tilt easily especially on a longish blade - take care of these facts.
Tue Jun 18, 2013 11:12 am
Yes, I get a burr on both sides every time. That makes sense that the tip is thinner and more flexible, but any practical tips on how to compensate/allow for that?
Tue Jun 18, 2013 11:55 am
Less tip overhang with less pressure on the stone arm.
Tue Jun 18, 2013 12:34 pm
Thanks MR. I'll try that.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.