It is currently Fri Jul 25, 2014 6:38 pm

All times are UTC



Welcome
Welcome to chefknivestogo

You are currently viewing our boards as a guest, which gives you limited access to view most discussions and access our other features. By joining our free community, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content, and access many other special features. In addition, registered members also see less advertisements. Registration is fast, simple, and absolutely free, so please, join our community today!





 Page 1 of 1 [ 2 posts ] 
Author Message
 Post subject: To Convex bevel or Not
PostPosted: Sat Aug 31, 2013 10:01 am 
User avatar

Joined: Sat Jul 20, 2013 9:36 am
Posts: 51
Location: Palma de Mallorca Islas Baleares Spain
I am new to using Japanese stones and have so far done the majority of my bevels as straight angles mainly so that I can learn to discipline my control .
I have done a couple of knives with convex bevels one was a hunting knife whose spine is 5mm and had little taper to a V ground bevel near 50˚ it was virtually blunt more like an axe so I re profiled the right hand side thinning from just below the spine to the edge and then convexing the lower third to the edge then putting a convexed micro bevel probable about 5-8˚, the left side I convexed the lower 25% and the put a convex bevel probable of about 10˚near the point terminating at the handle at about 15˚ the result is a razor it just slips through paper & feather sticking is effortless.

The question is that at my stage of sharpening with Japanese stones I am getting sharper edges with convex bevels this is not to say that I am trying to achieved an equal level of sharpness with flat bevels I imagine that will come plus I imagine that a Japanese knife like a Fugubiki has to have flat bevels or even Yangi to function properly ?

I think I already have the answer and that is I should work at flat bevels especially for finer quality Japanese knives.


Offline
 Profile  
 
 Post subject: Re: To Convex bevel or Not
PostPosted: Tue Sep 03, 2013 8:50 am 

Joined: Mon Sep 10, 2012 7:12 pm
Posts: 52
Unless it is a chisel ground knife I prefer all my edges convexed - but I do have a variable speed RadiusMaster to do the job.


Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


suspicion-preferred