Switch to full style
We have a massive amount of Edge Pro products so we figured it would be good to have a whole section on how to use the machine and what to use on it.
Post a reply

Springs for the Edge Pro

Tue May 29, 2012 4:38 pm

This seems like a trivial type of item but it seems popular to use a spring instead of the screw ball on the arm. Anyone like to show me a picture of yours and I'll try and hunt them down and stock them? I figure it could save some guys a trip to the hardware store.

Re: Springs for the Edge Pro

Thu May 31, 2012 1:48 am

Not my picture, but you get the idea.
http://www.eeaston.com/2011/10/edgepro-apex-springloaded-stone-holder/

Re: Springs for the Edge Pro

Thu May 31, 2012 7:49 pm

Re: Springs for the Edge Pro

Sat Jun 02, 2012 4:59 pm

I went out and found these so I should have them on the site and ready for sale later this week. I only bought a couple dozen but if there's good interest I'll buy a bunch of them and keep them in stock going forward. I also might add them to the sets since it's a cheap and nice thing to upgrade the sets with for new users.

Re: Springs for the Edge Pro

Tue Jun 05, 2012 2:52 pm

Ok, they are now in stock and ready to go. You can pick them up here:
http://www.chefknivestogo.com/edprocospfor.html

Here is a demo video on how to install it and use it.

Re: Springs for the Edge Pro

Thu Jun 07, 2012 12:28 am

Despite not having an EP, this seems like a big, perhaps even obvious, improvement.

Re: Springs for the Edge Pro

Thu Jun 07, 2012 2:10 am

I'm such a geek. I was actually very excited about getting these in.

Re: Springs for the Edge Pro

Thu Jun 07, 2012 6:37 am

Hmmm. I need to pick up one of those with my next order.

Re: Springs for the Edge Pro

Tue Jun 12, 2012 7:11 pm

Wow these are popular. I'm going to get a boat load of them and add them to the sets in a week or two. Getting 500 of them to hold me for a while.

Re: Springs for the Edge Pro

Sun Jun 17, 2012 10:55 pm

We just got 500 of these springs in. I'll be adding them to the sets this week.
Post a reply