Switch to full style
Post a reply

Pierre Rodrigue's Latest Knives

Fri May 11, 2012 7:30 pm

Hi Pierre,

Feel free to use this thread to post pictures of all your knives and forks etc as you make them.


Mark

Re: Pierre Rodrigue's Latest Knives

Sat May 12, 2012 12:32 am

Mark, thanks so much! I appreciate it, you have been nothing but fantastic since I have met you. Hey you want me to put up pic's of the new handles I've put together?

Re: Pierre Rodrigue's Latest Knives

Sat May 12, 2012 4:33 pm

Sure, anything goes for this thread. Post pics of customs you make, forks, handles, your shop etc.. We can use this for our new project that's about to roll out too as you make them.

Re: Pierre Rodrigue's Latest Knives

Sun May 13, 2012 5:43 am

A new set I put together, not sure if you guys seen them...

All CPM 154, G10 scales, stainless bolsters, white fiber liners, stainless pins with one mosaic.

Image
Image

Re: Pierre Rodrigue's Latest Knives

Sun May 13, 2012 5:45 am

a pre branding photo
Image

Re: Pierre Rodrigue's Latest Knives

Sun May 13, 2012 8:12 am

What a fantastic set!

Re: Pierre Rodrigue's Latest Knives

Sun May 13, 2012 10:17 am

Nice!

:)

Re: Pierre Rodrigue's Latest Knives

Tue May 15, 2012 2:58 am

Here are two more finished up today. Also included a before picture, so you can see how these started out. Again, these were forged in 1960 and are 1084 carbon, not stainless.
Image
Image
Image
Image
Image

Re: Pierre Rodrigue's Latest Knives

Tue May 15, 2012 10:20 pm

When are you going to send me a couple of these forks! I love them.

Re: Pierre Rodrigue's Latest Knives

Thu May 17, 2012 8:42 pm

The specs... 192 mm Nakiri
Alabama Damascus consisting of (4) layers 5160, (3) layers 203E, (3) layers 52100, (3) layers 15N20 folded 5 times for 416 layers.
At HRC 59-60

Edge 192 mm (7.56")
Height 55 mm (2.17")
Spine = 2.4mm (0.094") mid blade = 1.38 mm (0.054") 1 cm from tip = 1 mm (0.039")

Handle 148 mm (5.83") long X 16.5 mm (.65") wide X 22.5 mm (.86") high at ferrule and 21 mm (.83") wide X 25 mm (.98") high at the butt.

Handle is Desert Ironwood ferrule, white fiber and Western Plains buffalo horn spacers, And some of Marks (Burl Source) stabilized Sycamore

Knife balances 1 cm in front of the heel. Spine and choil rounded.

Image
Image
Image
Image
Image
Post a reply